Pair/Reed Valve block off...

ks-waterbug

Group Buy Guy
Donating Member
Registered
Thanks to Brock Davidson...

And a link to remove the octopus from your Gen II entirely https://www.hayabusa.org/forum/gen-...r-valve-solenoid-removal-gen-ii-hayabusa.html

http://www.brockracing.com/Instructions/S1308-PAIR%20VALVE%20MOD.pdf

pair.jpg
 
Last edited:
Could this possibly help with the stock exhaust? or would hinder more that help?
IMOP the factory knew best! I wouldn't modify this without installing an after market full exhaust system. Oh, and I did the marble mod... Works flawless
I have slip-ons and did the marble mod..... works great.  No more popping.
I have slip-ons and was going to ask that question. Thanks
thumb_up.gif
 
We have been doing the same thing, works great. I use a drain plug turned upside down.
thumb_up.gif
 
Is the popping on decell bad for the bike? My K8 does it a little since the full Yosh R77 but not too bad. It doesn't bother me and I was wondering if it hurts anything if I leave it alone?
 
Is the popping on decell bad for the bike? My K8 does it a little since the full Yosh R77 but not too bad. It doesn't bother me and I was wondering if it hurts anything if I leave it alone?
Good question ... even though I did the marble mod. all ready, will it cause any problems by blocking off the pair/reed valve? Will I gain or loose HP? What is the effect of this mod. other than to stop the popping of the exhaust?
 
Back
Top