Redneck engineered parts

[PACIFICBUSA]

Gotcha. Sounds doable....

 

[06BUSA]

the wire you see on this pic goes to my radar detector or gps or camera or whatever i can put on the stem stand. its hard wired to the battery. in another pic you can see how i turn it on and off.

Hope you fused that line.

 

[psycobusa]

the fuse is built into the male connector. had it like that for 3 yrs and no problems...knock on wood

 

[Warputer]

Haven't used the back country science on my Busa .......but have used it all out on my Jeep !

Plenty of homemade fab work will save ya big bucks ! She's on my avatar .

They got rednecks in Texas ?

 

[psycobusa]

they do now... just moved here from the MS Delta

 

[Warputer]

Gotta get yourself a cowboy hat now ! Different kinda redneck there ....

 

[TKTM8KR]

Gotta get yourself a cowboy hat now !  Different kinda redneck there ....  

+1

 

[BUSAFETT]

No southern specials on my Busa [yet, at least]-

However, my Chevelle's a different story

BUSAFETT

 

[psycobusa]

gettin southern specials on your busa in the Northeast US is as about as easy as gettin sweet ice tea up there

 

[BUSAFETT]

We have a Cracker Barrel- So we have the Sweet Tea

BUSAFETT

 

[bigoltool]

Ok I'll start with the little stuff here.
1)I made the switch mount for the heated grips out of Some "road sign" grade Aluminum plate I had laying around.
2)After I did the Genmar riser I hated the gaping holes it left above the adjusters. So I made some plugs out of Nickel Chair sliders (the ones with nails in em) and a little silicone sealant. Turned out really clean actually.

 

[bigoltool]

Then the bigger stuff. I didn't have the coin to buy a work stand so I made one out of wood. it is hinged in the middle and all of the legs bolt on with 1/2" bolts (eye bolts in front for tie downs) so the whole thing will break down into a 2'x4'x8" block sans ramp.Finally I fabbed up a wheel chock for the front of it (more road sign grade aluminum here) that bolts on with wing nuts. I even painted it with some copper spray paint I had to match my bike! Grand total for the whole stand was about $50 hardware and all.



<!--EDIT|bigoltool
Reason for Edit: "added pic"|1143350236 -->

 

[bigoltool]

chock!

 

[psycobusa]

nice job

 

[frisbee]

not bad

 

[IFLYLOW]

Bigoltool, thats not bad at all!!

 

[turbojonn]

I like this thread. You guys did some cool stuff.

 

[larrymaples]

same thing has been done to gas tank only whoever done was an idiot and cannot weld but i know now y it was done that way thanks i been trying to figure that out for a month

 

[EarlyBird]

Old thread brought back from the dead!

 

[BUBBA]

Old thread brought back from the dead!

GRAVE DIGGERS