removal of rear deflectors

[busabad]

Question,
I'd like to remove the rear deflectors on my 'busa but
when I turn the screws they just turn without coming out...
a little help here...what do I have to do to get these things out!
Thanks

 

[BigBSBusa]

The best way is to remove your seat/hump and then take off the tail section. After that you should be able to remove those suckers!

 

[ThunderPants]

Yup, or you can just pull down on the bolt while unscrewing them, should put enough tension on the nut to keep it from spinning. Of course you then have the nuts rattling around in there until you get around to taking the tail off.

 

[Haywood]

you mean REflectors, right? Take the tail off, it's really very easy to do. 6 screws (4phillips head under the hump(2 for the lock, 2 for the tail), 2 hex on the outside), 4 bolts (grab rail), 6 of those plastic little pushpin type thingies underneath, and then the 2 bungie cord tie-down jobs.

 

[BigDawg_03Busa]

I used the section of reflector being secured. What I mean as I
removed the front reflector I used my non-screwdrive holding hand
and pulled down on the reflector as I screwed. To do this I would
unscrew the front then the back and vice versa to even out distance.
Took me all of 5 minutes to remove both.

 

[fstbusa]

I used the section of reflector being secured.  What I mean as I
removed the front reflector I used my non-screwdrive holding hand
and pulled down on the reflector as I screwed.  To do this I would
unscrew the front then the back and vice versa to even out distance.
Took me all of 5 minutes to remove both.

I did the same!!!

 

[ROCKBUSA]

LIKE THEY SAID TAKE THE TAIL OFF