Replacing rear brake line - is this right?

[Gen3lover]

Appealing to the brain trust here. I'm in the final stage of stretching the rear a few inches on my 2022 Gen 3.
The last thing is to install a longer rear brake line. Per the Gen 3 service manual it appears to connect to a spot next to the front sprocket as shown in the picture.
Is this correct?
Or does it connect somewhere else?
Is there a video that shows installation procedures? If it just connects to the spot next to the sprocket then it's pretty straightforward.
Thanks in advance.

 

[Gen3lover]

Here's an image of the entire page from the manual for reference.

 

[LC4CARL]

If she’s similar to my, non-ABS, Gen 1, the rear master cylinder is on the right side above the brake pedal.

 

[Dustin02]

It connects to the abs module underneath the tank on the left side of the frame.

 

[Gen3lover]

Right, I now see that the manual page I included shows the master cylinder line. There is a second line from the ABS module to the caliper that I'm replacing.
So access is from the left side of the frame.
Any videos you know of?

 

[Dustin02]

Don't know of any videos. It's a fairly simple modification. Just follow the rear brake line to the abs module, then swap it and bleed it using the fitting at the abs module as a bleeder.

 

[Gen3lover]

Appreciate the info.