Tail Mod

[#cruncherbusa]

Nice!

 

[BLU88]

Here is my trim job .. all looks good with clear alternative.

 

[Postal]

Here is my trim job .. all looks good with clear alternative.

Very nice Blu!

P.

 

[1300Ryder]

I just got that same integrated tail light today. When I ordered it I was hoping it was pretty much plug and play, but now that I look at all the contents of the package.....I'm lost!
There was no instructions so could someone give me an idea of what I need to do here, I'm not much of a gear head.

ImageShack Links Do Not Work
ImageShack Links Do Not Work

 

[laken]

The resistors (the big white things) are going to connect to the yellow wires. The other sides connect to the turn signals (left to left, right to right) power wire. The red clips are what they want you to use for that, but if you don't plan on removing it I say do it right and solder it. The bulb connection goes to one of the rear bulb jacks. The o-rings are for the bolts. You don't want to screw down on the board and crack it. I don't know what those little pins are for...

The resistors make the turn signals flash at a slower rate. If you don't use them they are going to flash fast.

Where did you get it? and are you happy with the brightness of the LEDs?

 

[manatrader]

If you use the resistors make sure they get air flow around them, they get hot. I have the same kit and I do not use the resistors and I'm fine with the higher flash rate.

laken, the LED's are okay from behind, direct sunlight they have some problems not being bright enough.
At night no issue very bright.

 

[Devil Dog]

Sweet...I just did mine, though it looks great, yours is much better.

 

[BusaWhipped]

Just did a tail mod with my Dremmel to get rid of the blinker holes. Also installed the "Clear Alternatives" LED tail light (smoked lens) with integrated turn signals. Love it!

Postal.

Nice.