What Goes Here?

[NickSully]

The small ones are VERY easy to remove ???

Just push in the center of the pin...then they slide right out. To reinstall, slide the center pin out of the rivet about a 1/4"...then put the rivet back in the panel that it came out of...once it's in there flush...then push the center pin in flush with the rivet. You will here a little 'snap' noise when you remove and or install these little "push pins"
Posted via Mobile Device

That's sounds oddly familiar

 

[neoBusa]

3 different sizes?

I'm with you, Michelle - I can't think of three sizes, only two...

exactly, on the Gen II also 2 sizes, long and short pins

 

[BA BUSA]

That's sounds oddly familiar

Not even close, you didn't tell him how to put them back in or the 'snap' that lets you know that you did it right
Posted via Mobile Device