Which map for cut mids?

[V8N3T]

Ok, so I just got my pc3 and I am wondering which map to use.
Also, I am wondering how to properly set the pc3 with the adjustments. Should I just load the map, and plug and play? Or should I set it to high? Where should my green light be on the level bar? Just wondering about the settings, dont want to have it running like crap because I set it up incorrectly.

 

[sproket]

Have to dyno it to make sure the mixture is right, More than likely it will make a loud pop EVERYTIME you decelerate from high revs....
IMO...Just remove the cans and try to map it that way before you cut it off...

 

[V8N3T]

sproket, its already been cut. And I honestly dont wanna pay $300.00 to have it dynod. Although it would be nice.

 

[BA BUSA]

(V8N3T @ Dec. 08 2006,17:37) Ok, so I just got my pc3 and I am wondering which map to use.
Also, I am wondering how to properly set the pc3 with the adjustments. Should I just load the map, and plug and play? Or should I set it to high? Where should my green light be on the level bar? Just wondering about the settings, dont want to have it running like crap because I set it up incorrectly.

Ron's bike has a map for a stock bike with Bolt ons...the stock header is the power restriction, so try that one first

 

[sproket]

well...i hate to tell you to keep leaning out the mixture till it stops popping cause you may damage your bike....but if you smell too much gas from the exhaust AFTER a ride NOT just starting and stopping engine....thats one way to kinda tell if its rich or lean...
I have seen that mod done before and when it pops it sounds like a gun going off...