Looks like the gate needs to be down to carry the Busa. But it looks like a fantastic ride! I always want brand-new, but if it saves your enough and they'll give you some type of warranty ... I'd say go for it!
Jinkster, have you determined if the busa will fit in the bed with the gate down or not?
Sax..that was of course a very important issue to me..as due to the fact that this family man not only wanted but NEEDED a true 4-Door Crew Cab?...then add the fact that I didn't want a crewcab that also had a "long bed" because the resultant ultra-long wheelbases of such vehicles sux..they are like driving a freaking schoolbus...turning radiuses are hideous...u-turns are no longer an option (even on mulitple lane highways) and general gett'in 'round town and parking becomes a mini-nightmare..which altogether is a huge P.I.T.A.
So...want cab room?..yet with and acceptable level of handling?...and a bed that can take a busa strapped headlong and straight up?...concessions had to be made...tailgate hasta remain in the down position...and here's the numbers...
The busa measures approx. 70"s fron the front of the front tire too center wheelbaseline of the rear wheel...and OAL of the busa is approx 84"s...
The Actual Titan Bed: with the tailgate down the entire bed/tailgate surface is 90"s long...the truck bed surface measures 67" then there's about a 2-3" jump/gap from the end of bed surface to beginning of tailgate surface which places the busas 70" centerline of the rear wheel almost exactly over the tailgates mounting/hinge-points..the strongest spot on the tailgate with right at zero leverage factor...so yes...the rear will be on the tailgate but...the very front hingepoint of it...I'm calling that good to go...and in actuality?..it's not tying the busa down to the tailgate that is the critical issue...the critical issue is just as with ALL pickup trucks with tailgates...as unless you have a reeeeal longbed where you can actually "REMOVE THE TAILGATE ALTOGETHER"?...max load on the tailgate occurs not when strapped down but when loading up..as folks will rest the end of their respective ramps right on the tailgates extreme end where MAX LEVERAGE is achieved and then they ride their 500LB + Rider busa up into their truckbed....with the very end of the tailgate taking the full leverage load of ALL..so if it's gonna break?..that's when it'll happen...loading up...on a tailgate..and I did exactly that with my old '03 Tundra dozens of times..with both my FZ1 and my Busa...not a problem...and I don't suspect it'll be a problem on the Titan either...and over the years?...I've seen literally 100's of bikes ramp loaded on tailgates....and never even so much as "Heard Of One Breaking Or Tweaking Out" let alone seen it happen...never..so again?..I'm calling it good-to-go....and tailgate down?..the crewcab titan will most definantly pack a busa.
L8R, Bill.