Falkonworks
Registered
Here is my pass from the event over the weekend. This was a quarter mile speed run. We only were given a single pass. I ended up going 155MPH and was the fastest of the day.
StreetShark's Hayabusa
- Thread starter Falkonworks
- Start date
Great run ......
I can't remember if you have a quick shifter.....I'd imagine you do as those are smooth shifts....
Falkonworks
Registered
Yep I have the Woolich quick shifter. The pass wasn’t the best I can do, but all that matters is that it was better than everyone else I guess. We were given a single pass, with no prep, and no burnouts. I wasn’t sure if I was going to get any traction at all but it turned out ok.
Falkonworks
Registered
Some photos from the car show / race event over the weekend. My bike parked with a buddies B-King project bike, and the turbo ZX-14 that came in second behind me at 153MPH
Falkonworks
Registered
Yeah the owner and I discussed that before the racing started. She said she was somewhere between 8-10 over. The bike is way too long and she plans to shorten is up quite a bit and that’ll definitely help. Were talking about Shift Sector next year so maybe we’ll see that bike out in Indy as well.
Falkonworks
Registered
New front stay showed up today for the Busa. Plan is to install it tomorrow and then get some bars made. This is where we’re at right now.
Falkonworks
Registered
From the event a couple weeks ago
Falkonworks
Registered
I made a couple revisions to my lock cylinder design.
The threads are now integrated into the knob instead of using a separate screw to hold everything together. This should eliminate the possibility of the knob slipping during operation (I had a couple customers report this on ZX10s).
I am also using 7075 instead of 6061 now.
If anyone here is interested in picking one up, the pre order is available now
falkonworks.com
The threads are now integrated into the knob instead of using a separate screw to hold everything together. This should eliminate the possibility of the knob slipping during operation (I had a couple customers report this on ZX10s).
I am also using 7075 instead of 6061 now.
If anyone here is interested in picking one up, the pre order is available now
PRE-ORDER: Trunk Lock Cylinder Delete (Updated Design) — FALKONWORKS
THIS IS A PRE-ORDER ITEM LIMITED TO 20 UNITS PRODUCTION WILL BEGIN AFTER ALL SPOTS HAVE SOLD * Updated design with screw built into shaft to eliminate the potential for slipping * Bikes that have had key switches removed typically have either a lock cylinder for the trunk which still requires a
falkonworks.com
Falkonworks
Registered
Falkonworks
Registered
Made some new lightning weave bars today
I was going to install them today and found out the plastic alignment pin for the controls is broken. I know Brock’s makes one, but I designed my own today and the test part is printing now.
I was going to install them today and found out the plastic alignment pin for the controls is broken. I know Brock’s makes one, but I designed my own today and the test part is printing now.
Falkonworks
Registered
Test print fits perfectly. I’ll likely be making a few of these from 7075 soon
Falkonworks
Registered
Tank bracket hardware is finished up. I’m going to be starting pre-orders on brackets soon-ish. With each part I release I’ll be adding more hardware to my catalog and will at some point start offering hardware on its own.
Falkonworks
Registered
Finally got a chance to go through my clips and get a video uploaded from Indy
Similar threads
